Hardware Drivers blank - can't use motion sensor
Posted: Sun Dec 18, 2016 2:53 pm
Hello there,
I have recently had to nuke my gateway and fork out for a whole new one. I've installed all the new hardware including a motion sensor and gateway nuke, however when I go to the bit to run the motion sensor program, the "Hardware Drivers" part is blank when I mouse over it. I've checked my gateway setup and they are both definitely installed, however I can't seem to run them.
Is this normal behaviour? I don't really want to start being naughty again without having my failsafe.
Any info would be greatly appreciated. Cheers,
Ken
I have recently had to nuke my gateway and fork out for a whole new one. I've installed all the new hardware including a motion sensor and gateway nuke, however when I go to the bit to run the motion sensor program, the "Hardware Drivers" part is blank when I mouse over it. I've checked my gateway setup and they are both definitely installed, however I can't seem to run them.
Is this normal behaviour? I don't really want to start being naughty again without having my failsafe.
Any info would be greatly appreciated. Cheers,
Ken