Hardware Drivers blank - can't use motion sensor

Stuck in Uplink? Need Help?

Moderators: bert_the_turtle, jelco, Chris, Icepick, Rkiver, Punisher Bass

Posts: 1
Joined: Sun Dec 18, 2016 2:48 pm

Hardware Drivers blank - can't use motion sensor

Postby DirtyKen » Sun Dec 18, 2016 2:53 pm

Hello there,

I have recently had to nuke my gateway and fork out for a whole new one. I've installed all the new hardware including a motion sensor and gateway nuke, however when I go to the bit to run the motion sensor program, the "Hardware Drivers" part is blank when I mouse over it. I've checked my gateway setup and they are both definitely installed, however I can't seem to run them.

Is this normal behaviour? I don't really want to start being naughty again without having my failsafe.

Any info would be greatly appreciated. Cheers,

Return to “Hints and Tips”

Who is online

Users browsing this forum: No registered users and 1 guest