Tracked too fast

[elcisco]

I'm on a mission where i need to change some dudes identity from deceased to employed. I use the password breaker to breach the system which takes me up to about 40% tracked then i need to search for him and use the proxy disable. by the time the proxy disable is about half way through im alrready on about 90% so i have to disconnect. Ive tried upgrading my cpu to see if it goes faster but nothing noticable. Is there a technique? do i need some new software? thanks a lot, Cisco

[Kendo THM]

No... What you can do is that you bounce alot of times and connect to the social security Database.

Then run your Proxy Disable. Put it on full, Wait until the tracing starts and then use your password braker and put that on full.

Before you are even finished using the password breaker, the proxy is done and you've got enough time :biggrin:

(Edited by Kendo THM at 2:20 pm on June 8, 2003)

[elcisco]

aaah, i see. i though you had to use the proxy disable when you were inside the computer, nice one!

[Kendo THM]

As long as you're connected to the site...

[Kendo THM]

I guess you're just testing out what I just said, right?

And ??? Did it work ???

[rTux]

At the top of your screen is a little meter that reads something like "CPU power" or something. If you try dedicating more power to your Password Breaker, it will work a bit faster. Same goes for the Proxy Disabler too. Dont use too much that your Trace Tracker stops functioning though.

[Kendo THM]

Thats what I meant :biggrin:

[rTux]

Oh, whoops, my bad hahah.