Hardware Drivers blank - can't use motion sensor

Stuck in Uplink? Need Help?

Moderators: jelco, bert_the_turtle, Chris, Icepick, Rkiver, Punisher Bass

DirtyKen
level0
Posts: 1
Joined: Sun Dec 18, 2016 2:48 pm

Hardware Drivers blank - can't use motion sensor

Postby DirtyKen » Sun Dec 18, 2016 2:53 pm

Hello there,

I have recently had to nuke my gateway and fork out for a whole new one. I've installed all the new hardware including a motion sensor and gateway nuke, however when I go to the bit to run the motion sensor program, the "Hardware Drivers" part is blank when I mouse over it. I've checked my gateway setup and they are both definitely installed, however I can't seem to run them.

Is this normal behaviour? I don't really want to start being naughty again without having my failsafe.

Any info would be greatly appreciated. Cheers,
Ken

Return to “Hints and Tips”

Who is online

Users browsing this forum: No registered users and 9 guests