I have recently had to nuke my gateway and fork out for a whole new one. I've installed all the new hardware including a motion sensor and gateway nuke, however when I go to the bit to run the motion sensor program, the "Hardware Drivers" part is blank when I mouse over it. I've checked my gateway setup and they are both definitely installed, however I can't seem to run them.
Is this normal behaviour? I don't really want to start being naughty again without having my failsafe.
Any info would be greatly appreciated. Cheers,
Stuck in Uplink? Need Help?
1 post • Page 1 of 1
Who is online
Users browsing this forum: Yahoo [Bot] and 1 guest