Page 4 of 4
Re: Prison Architect Alpha 23
Posted: Tue Aug 26, 2014 11:29 pm
by Heffernan
JASPer.Gamer.9.0 wrote:almost time for pa 24
i wish people who update a 15days old thread that makes it look for people like theres a new version should die horrible...
Re: Prison Architect Alpha 23
Posted: Wed Aug 27, 2014 12:17 am
by RGeezy911
Remember, the email notifications tell you whether it's a new post, or a new topic! (Only if you subscribe to receive alerts for this forum)
If it's a new topic, then you know it's a version update (or something else more important).
Re: Prison Architect Alpha 23
Posted: Sun Feb 01, 2015 9:59 am
by mathew5502
Hi, please check out this video which shows you how to install CCTV
https://www.youtube.com/watch?v=KWTo2GtslnQHope it helps!
Re: Prison Architect Alpha 23
Posted: Sat Feb 21, 2015 3:59 pm
by FoxtrotDelta3
I was wondering if you could explain a little further how to use logic circuits and logic bridges? Like show a configuration for something simple so that I could get the idea of how it connects and explain what each of the and, or, what NAnd and xor is.. etc. Every time I connect a logic circuit, 2 doors, and a door control system it either A: opens the doors and leaves em open because the logic circuit is getting a constant signal, B: the doors don't operate at all, or C: the doors constantly start opening and then closing rapidly causing them to open just a tad bit then close a tad bit and back and forth. The door control panel doesn't work at all for me when I have it set up and i'm not entirely sure what i'm doing but I'd like to find out or at least get the gist of it so that I can experiment with it more. Thanks
Re: Prison Architect Alpha 23
Posted: Mon Feb 23, 2015 5:18 pm
by _alphaBeta_
FoxtrotDelta3 wrote:I was wondering if you could explain a little further how to use logic circuits and logic bridges? Like show a configuration for something simple so that I could get the idea of how it connects and explain what each of the and, or, what NAnd and xor is.. etc. Every time I connect a logic circuit, 2 doors, and a door control system it either A: opens the doors and leaves em open because the logic circuit is getting a constant signal, B: the doors don't operate at all, or C: the doors constantly start opening and then closing rapidly causing them to open just a tad bit then close a tad bit and back and forth. The door control panel doesn't work at all for me when I have it set up and i'm not entirely sure what i'm doing but I'd like to find out or at least get the gist of it so that I can experiment with it more. Thanks
You may find
this thread useful, and others like it. Some of the limitations are also described.